I think i know the answer to this, and will not name the wood provider at this time, as I do not want to slam their name in the event they take care of me. I ordered a piece of AA grade red spruce torrefied from a supplier, looked good, white both sides, near vertical grain. jointed it, glued and cut profile and started carving, about an in. below the top point., and an in. or so in, a knot shows up, and does not look like I can carve it out.As I was carving it was just a wave in the grain as though it were bearclaw. Is this something any of you would use? I am thinking no. and is this something a supplier should stand behind? thanks
Bookmarks