Plexi for templates
I was going to make some templates from plexi but I have had no success cutting it. Fine blade on a band saw not smooth enough chipping. Slow speed saber saw very fine blade no joy cracked the piece. Started hand cutting with a coping saw but way to slow and still not as nice of an edge as I want. Perhaps my sheet is to thin? 3/16 or less. I have also wondered why not use a nice chunk of MDF? If I decided I wanted plexi after the mdf I could use it as a template for a flush cut router bit. Any suggestions or advice welcome.
Thanks!
My avatar is of my OldWave Oval A
Creativity is just doing something wierd and finding out others like it.
Bookmarks