Fret board lube and strings
I was excited to get my TI strings installed and I now do not want to pull them off but in the process I forgot to line my board and it could use it. I was considering using a q-tip to get under and around the strings but it is inevitable that the lube will at some point touch the strings. Is this going to be an issue? I thought about putting some wax paper under the strings and the working from the side but if it isn’t an issue then it isn’t worth wasting the time it takes to wrap them up. Normally I would just replace the strings hit these are TI flats and are expensive so I don’t want to ruin them. Thanks!
My avatar is of my OldWave Oval A
Creativity is just doing something wierd and finding out others like it.
Bookmarks