Re: binding channel cutting options
Seconds after routing my first binding channel in a spruce top, with the set up that the OP describes, I knew that it was not going to be powerful enough for the hard maple back (I ended up not binding it all, that was easy!)
There are certain tasks that require specific tools, for safety and accuracy.
I cut electric strikes into metal door frames and in my opinion there is only one tool that should ever be employed to do that with and that is the Dremel Ultra-Saw. Their weak-ass standard rotary tool is almost invariably disappointing for all but the lightest of tasks.
But Amsterdam was always good for grieving
And London never fails to leave me blue
And Paris never was my kinda town
So I walked around with the Ft. Worth Blues
Bookmarks