-
Widening endpoint hole for jack
Sorry if this has been covered before, but what method do you use to open up the end pin hole in an Allen cast tailpiece for a pickup jack? Reamer? Step drill? Other?
Thanks.
-
-
Manndo Mannufacturer
Re: Widening endpoint hole for jack
I use hand reamer with tailpiece mounted...touch up burrs with small file.
-
-
Registered User
Re: Widening endpoint hole for jack
If its a real tapered endpin so there is a through hole, use a reamer. Size depends on the jack you're using. If you need to enlarge the brass tailpiece, use a stepless drill bit (http://m.harborfreight.com/3-piece-s...not%20provided)
If you have a screwed in strap button instead of an endpin use a brad point drill bit. Again, size depends on the jack you're using.
-
The following members say thank you to Mandobart for this post:
-
Re: Widening endpoint hole for jack
-
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks