Neck to body......

[reb0964]

Im having a hard time figuring out the angles and cutting joints for neck to body,,,is there anyone tha has built jigs or a simple way to do this thats accurate each time,,,,im on my third mandolin and still figuring this out,,,Help me out??? Thanks Russell

[sunburst]

To answer your question, yes there are jigs.

For my mandolins, a jig wouldn't be accurate every time, because I vary the height of the top arch a little bit, and I sometimes vary the bridge height a little bit. Either one of those will change the neck angle.
Unless your arch is the same height every time, your overstand height is the same every time, and you use the same target bridge height every time, you can't use the same neck angle every time, so you can't make a jig that is accurate every time unless it is adjustable, and you never make any mistakes adjusting it.

[labraid]

I measure the bridge height I need with a variable angle gauge, then based on a tangent calculation, this guy helps me through the bandsaw to get it pretty close.

best,
Brian

[french guy]

Russel , I always use the V notch and I do all the process
with the circular saw .
look here for the body part : http://perso.orange.fr/jl-mando/cons...ssemblage.html

and here for the neck part :
http://perso.orange.fr/jl-mando/cons...us_manche.html