This is the only gun I've ever used for sunbursting. Got it in 1981. It was recommended by one Mr. Kemnitzer as an all purpose color and lacquer gun. Got a bigger Sata for lacquer but the Binks is still great for shellac seal coats.
This is the only gun I've ever used for sunbursting. Got it in 1981. It was recommended by one Mr. Kemnitzer as an all purpose color and lacquer gun. Got a bigger Sata for lacquer but the Binks is still great for shellac seal coats.
Thanks, John. Clear, concise, good advice. I did a little testing on scrap but the final color result really didn't matter a whole lot to me on this one. I got plenty of experience removing the lacquer and redoing the finish several times to try different approaches, so it was a good schooling for me. All of my instruments have been hand rubbed stain, and all but one have been french polished with shellac based finishes, so the real lesson was that spraying tinted lacquer is a bit different technique and not quite as easy as the videos make it look. Couldn't tell from Spruces posts if he has experience spraying lacquer, but I wanted to advise some caution if he hasn't done it.
Unfortunately, I do...
Gawd, I hate the stuff, and am pretty sure it's caused the deaths of quite a few in the luthier community...
I'm not very good at spraying lacquer, but you don't really have to be if you're mostly doing antiquing...
Got a pit in the finish?? No biggie--we'll make it a ding...
Orcas Island Tonewoods
Free downloads of my mandolin CDs:
"Mandolin Graffiti"
"Mangler Of Bluegrass"
"Overhead At Darrington"
"Electric Mandolin Graffiti"
As for testing on scrap, isn't it also wise to test on scrap from the same material (scrap from the "trimmings") rather than scrap old another piece of similar specie?
Does that make any sense?
I mean test a scrap of the same specific material not just a similar piece of spruce or maple or any other stock.
Talk about making the point the hard way!
Timothy F. Lewis
"If brains was lard, that boy couldn't grease a very big skillet" J.D. Clampett
I suppose it would be ideal to test on scrap of the same wood, but that isn't always feasible. Similar wood will yield similar results, so that is the route most traveled.
What is more important is to prepare the scrap in the same way as the actual work. That means sand it thoroughly to the same grade of sandpaper and use the same color/finish materials and procedures as the actual work.
John Hamlett
www.hamlettinstruments.com
Once again, good point John!
Timothy F. Lewis
"If brains was lard, that boy couldn't grease a very big skillet" J.D. Clampett
Bookmarks