Very cool. Vermont is a beautiful state.
Very cool. Vermont is a beautiful state.
I am not sure I can answer this question fully but I’ll give my opinion. Personally what I think you should pay attention to are not temperature but humidity changes:
- I have a Big Muddy. It is a...
I live in New Hampshire and am a novice.
I've never played or even seen a Red Valley (in person), but I have a Mid Missouri (Big Muddy) mandola that I bought used and which I like very much.
My...
When I owned a finishing shop I considered fire resistant waste cans a necessity. John has it right, the lacquer rags aren’t the problem when it comes to spontaneous combustion, it’s the oil rags....
Oil finishes and varnishes that cure by polymerization are the ones that can catch fire spontaneously because the curing process is exothermic (gives off heat) and oily rags can heat up and catch...
That's what I paid for my Silver Angel Econo last year, haven't noticed what Ken's been asking for them recently.
Howard Morris...
https://www.mandolincafe.com/ads/199137#199137
NFI
Conventional wisdom is that hard cases offer a more stable environment (and better retention with in case humidifiers as well as more gradual humidity and temp transitions when changing...
I was in a similar situation. I moved to the Rochester, NY area from Arkansas in 2016. The humidity is as bad in the summer in Rochester as it was in Little Rock, but low humidity is a big problem in...
I live not far from Vermont, and second Rob Roy's advice above (post #3). Travelling in Fall shouldn't be too grim if you're not opening and closing cases a lot. I've fiddled with snow on the ground,...
Get a hygrometer and keep close tabs on the relative humidity. When it drops below 40% use case humidifiers and keep your mandolins in their cases when not in use. Depending on the heat source, you...
First, it helps if you have a place to live that's got good insulation, and not drafty, because then the indoor climate changes won't be "drastic." Then, keep your instruments in their cases, and...
I also ended up buying some sandpaper and stuff, because I had to sand down the bottom of the bridge (this was on my Kentucky KM200S). Which was not too bad to do, just time consuming for me. (And...
The only think I bought was a cheap set of feeler gauges which became my files for nut and bridge. Cost about £5. Oh, and a new blank nut after I messed up by going too low. ;)
Our puppy (6 years ago, now a good dog) chewed everything in sight -- chair legs, books, screwdriver handles, shoes, remotes, well, the list is too long -- she would also bite anything approaching...
For less than $20, you can get a dog gate and confine the dog to whatever room is next to where you want to play. Get the dog used to listening.
Oh, and keep them cases out of reach too. My dog is...
You can get all the the stuff you need for short $ at Harbor Freight. Rob tells us this in his book. I bought everything he suggested, and I think it set me back maybe $20.
What's your budget? If it's <$100 I think you may be outta luck. Cheapest one I could find with a reliable shop set-up was a Rover RM-50B at Elderly Instruments, and that was $255.
Lots of...
Seriously, particularly this year, if someone goes missing from our community it's natural to hope they're ok.
I take this thread, and most threads here in the Cafe, at face value.
We miss...
I'm with Em. I wouldn't appreciate a discussion of my personality or behaviour on the Forum. If anyone's unhappy with things I say, I'd hope they'd either address me personally, perhaps through a PM...
At least he didn’t take up the banjo.
Sounds like he went over to the dark side.
He’s over on the Acoustic Guitar Forum
For those of you so inclined, I would ask that you keep Dennis Vance in your prayers. He is facing some medical issues that must be addressed in the near future. I do not wish to, nor do I intend to...
Here are some pics of my Morris, built in 2010:
Under construction
186358
186359
Brand new
186360
186361