Re: Wearing down to the wood on my MT
Daniel, the mylar material (self adhesive) is available from Stewart MacDonald and can easily be applied yourself. Just cut a piece to cover the area (larger and shaped). Flood the area with a small amount of water to sueeze out bubbles. Place paper towel any where the water may be unwanted (inside f hole). Remove the adhesive cover film, place one edge down press down kind of rolling it on to the surface to push the water away. Work any air bubbles out to the edge and it's done. Way harder to describe than do. To remove in the future (if wanted) warm waith a hair dryer and slowly pull up from surface.
Dave
Heiden A, '52 Martin D-18, Taylor 510, Carlson Custom A with Electronics
Bookmarks